How to Build a Lighthouse Out of Cardboard - how to make a cardboard stand-SAFEKA-img

How to Build a Lighthouse Out of Cardboard - how to make a cardboard stand

by:SAFEKA      2019-07-22
How to Build a Lighthouse Out of Cardboard  -  how to make a cardboard stand
In the 13 th century, the Maya used the Lighthouse for the first time.The Romans, Greeks, Egyptians and Phoenicians also used the lighthouse to show the sailors along the coast.During this period, the Egyptians built the highest lighthouse, 900 feet high.
While fire and candles were used to illuminate the path of ancient sailors, electricity created the lighthouse in today's society.Most lighthouses are cylindrical but square.You can also see Lighthouses of different shapes.
Build a lighthouse model with cylindrical cardboard.Place the 12-by 18-Inch cardboard on a flat working surface, so 12-The bottom is inch edge.Place a marker 1 inch from the top right corner of the rectangle.
Align the edge of the ruler with the mark and the lower right corner of the cardboard.Draw a line that connects two points.Draw four 1/4-Square inches evenly distributed on the top edge of the cardboard.Place the top of each 2 1/4-3/4 square inches from the top edge (11-Inch edge of cardboard ).
Wire cutting along the painting.
Squeeze a line of hot glue along the cutting surface of the cardboard.Roll the left side of the cardboard on hot glue water.Overlap the left side of the cardboard 1/2-Line inches along the glue and place the overlap.
Press in place.
Add more hot glue under the flap if needed.Erect the finished cylinder so that the small end is on top.Position the point on the compass at 8-by 8-A piece of cardboard in square inches.
Push the compass point slightly into the cardboard to mark the center of the circle.Draw an 8-inch circle.Cut out the 8-inch circle.Position the edge of the ruler on the center point and make sure to extend the length of the ruler from the edge of the circle.Draw a line along the edge of the ruler.Move the bottom edge of the ruler from the first line to 3 inch.
Keep the top edge of the ruler on the center mark.Draw a line along the edge of the ruler.Take the ruler off and cut out the pieRound triangle.Squeeze a line of glue along one side of the pieTriangle.
The relative edge of the pie-Form a triangle on the glue line to ensure that the cardboard overlaps about 1/4-inch.This is the roof of the lighthouse.Set aside with the top point.Squeeze a line of glue along the top edge of the cylinder.Immediately place the roof of the lighthouse on the hot glue water.
Gently push in place.
Squeeze out a drop of four-point paint on the paper tray.Paint the lighthouse the desired color.Make sure to draw an entrance at the bottom.Let the paint dry for 15 minutes.Place LED faucet lights on a flat working surface.
Turn on the LED light.
Put the completed lighthouse on the tap light
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...
Thank you for contacting us. If for a timely reply now, you can contact following as well: Skype: ophelia.lee3 Wechat/whatsapp/phone: +86 15986640355